Farmall & IHC Tractors Discussion Board |
Re: riveting rear steel wheel hubs for Farmall Regular
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ludwig on April 25, 2002 at 13:58:03 from (209.213.208.66):
In Reply to: riveting rear steel wheel hubs for Farmall Regular posted by Loren Pribyl on April 25, 2002 at 10:37:42:
If you get it figured out post here. I've got the hubs from when they cut off the steel and put on the rubber, and I've got the steel rims. I think it'd be nice to have them back together again. One of my steels is still complete so I can make a template to make new spokes. I was going to use bolts, but if you figure out rivets I'd give it a try.
Follow Ups:
Home
| Forums
Today's Featured Article -
Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|