|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: '67? - 706
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jal-SD on April 24, 2002 at 11:46:59 from (64.68.166.199):
In Reply to: Re: Re: Re: Re: '67? - 706 posted by Joe on April 24, 2002 at 11:09:49:
Joe, Steven is right on being careful w/a narrow front. Grew up w/loader on narrow front H's-still have one w/loader. Best advice is to NEVER move the tractor in ANY DIRECTION w/loader in a position where you can see UNDER the bucket at ANY TIME, even w/empty bucket. Turning is dangerous, but backing & turning is the most dangerous. When you get to where you need to lift the loader to the proper dump height, stop tractor, lift loader & then move to dump position AS SLOW AS POSSIBLE. Takes more time, but at least you'll have time to take. (My $0.02 worth. jal-SD)
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
