|
Farmall & IHC Tractors Discussion Board |
Re: Finish mower for M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jim in Wisc. on April 20, 2002 at 19:49:55 from (209.240.222.132):
In Reply to: Finish mower for M posted by TNR on April 20, 2002 at 17:00:00:
Depends on how serious you are about mowing.....I pull a 7 footer with a "H" and pull a 9 footer with a "M"...both are finish mowers... the 7 footer is an IH stalk chopper(pull type) I rebuilt with front dolly wheels and took the big blades off and made new style drums with 4 blades on each of 2 drums....the 9 footer is made by Woods ...pull type ...by as far as making marks...I put 20.8 x 38's on "M" and has very little tread...and the "H" has 18.4 x 38's with very little tread so if I make marks they are minimal...but you must know the lawns I mow are at a church and a community center and rifle range and two shopping centers which add up to about 40 acres a week and trees are not a problem....if trim is needed it's done with a 20 hp garden tractor with a 5 foot deck........good luck...
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|