|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Question went unaswered on CASE board
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BIG JOHN on April 11, 2002 at 19:06:34 from (152.163.195.208):
In Reply to: Re: Re: Question went unaswered on CASE board posted by Brent on April 11, 2002 at 05:29:13:
If you look at the underside of the drive line you will see that the clutch housing is not a part of the transmission. There are two what look like drain plugs (at different levels)that are inspection plugs. They are only about 1" in dia. so might not be of much help if the pieces are larger than the hole. With the starter off and a light in the whole you will be able to get a look at the clearance you have in the bottom of the clutch and flywheel and decide wheather to leave or remove the pieces. It is possable to flush out small pieces with solvent. This is not a CIH fix though. GOOD LUCK
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
