|
Farmall & IHC Tractors Discussion Board |
Re: Re: sanity check on my 41 H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Honkey on April 10, 2002 at 09:57:58 from (64.68.163.36):
In Reply to: Re: sanity check on my 41 H posted by Craig MO on April 09, 2002 at 18:16:04:
A pressure check would be good, but there are no o-rings on the sleeves for a H so if there is anti-freeze leaking around the sleeve during a pressure check, then your block is cracked. Also, If there was a crack near an oil galley, there would be oil in the water, not water in the oil. I would retorque the head then pressure check and see if that fixes it. If not the head is most likely warped or cracked. Good luck
Matthew in SD
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
