|
Farmall & IHC Tractors Discussion Board |
Re: Difference between W-4 and I-4
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave_ID on March 27, 2002 at 15:39:56 from (63.15.161.198):
In Reply to: Difference between W-4 and I-4 posted by John in Md. on March 27, 2002 at 15:22:39:
The I-4's are alot more rare than the W-4. The I-4 is about 8 inches narrower, it has a foot throttle, and some have a heavy duty front end. I had one, but sold it. I didn't care to restore it, mainly everything is positioned so close together that it's hard to work on it. Just removing the starter is a pain. I picked mine up for $500, it had real good sheet metal. I fixed the starter, and carb, and it ran very good. I sold it for $800 last fall, and I knew I could've gotten $1000 for it, if I had waited for spring.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|