Farmall & IHC Tractors Discussion Board |
Re: f-12/C pistons
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmalldan on March 27, 2002 at 06:35:59 from (64.154.26.248):
In Reply to: f-12/C pistons posted by Flyin Farmall on March 26, 2002 at 20:48:11:
Most A, B, and C pistons of the appropriate bore (i.e. 3" bore in 3" sleeves, etc) will work in the F12/14 (with IHC engine). I would recommend that increased compression pistons be checked for clearance in the F12 as the combustion chambers may be different. Most aftermarket sleeves also interchange. The factory sleeves may not interchange into the F12 because the waterjacket on the A, B, and C was made deeper. Consequently, the seal surface does not extend as far up the sleeves and will not permit installation into the F12. Most aftermarket sleeves had the longer seal surface on all sleeves to reduce inventories and would work in either series. I don't know if IHC changed to this type sleeve or not. I don't know if the rods interchange or not. The rod journal bearings appear to be the same, so if wrist pin and center-to-center length is the same, they should work.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|