|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: 856 1st gear doesnt work in all ranges and with T/A back or forward?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JD Humm on March 26, 2002 at 15:45:22 from (67.202.50.245):
In Reply to: Re: Re: 856 1st gear doesnt work in all ranges and with T/A back or forward? posted by Keith on March 26, 2002 at 08:36:54:
That is precisely the shaft that lost the nut on Dad's 1256. I recall the keeper tab wasn't bent over and I don't think the nut was ever torqued properly to begin with, the tractor most likely didn't have 200 hours on the TA job when this happened. I just torqued the nut to specs and made sure the tab was bent down like it was supposed to be, never had anymore trouble out of it. I had heard of this happening to other tractors though. Maybe locktight as well???????
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
