|
Farmall & IHC Tractors Discussion Board |
Re: Finally Painted Some Super C Parts Today and My Shoes
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Toyfarmer on March 24, 2002 at 23:46:35 from (198.81.17.187):
In Reply to: Finally Painted Some Super C Parts Today and My Shoes posted by Toyfarmer on March 23, 2002 at 22:09:08:

Here is what I was able to complete today. As you can see from the picture I have a long way to go. I hope to get the engine and front end put on next weekend. I am very lucky in that I work in the body shop at a Ford automotive dealership (parts guy). The painter mixed the DuPont paint and let me use one of his older spray guns (not sure what type). There are a lot of tractors around here that have 42" tires, I have heard people call them California Specials. The crops we grow require a tractor with good ground clearance. I have even seen 4x4 tractors with 54" tall tires front and rear. We call them mudders, because they usually work in the wet fields of celery, cabbage and lettuce.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|