|
Farmall & IHC Tractors Discussion Board |
Re: Pickup Truck Haulers
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Rider on March 14, 2002 at 20:15:46 from (67.226.10.20):
In Reply to: Pickup Truck Haulers posted by Cseries on March 13, 2002 at 20:33:02:
I pull a 24' deck tandum dual tired goose neck with a 1984 GMC 3500 dual tire rear axle, flat bed 4X4 with a 454, 4 Speed with a ranger spliter and 4.10 axle ratio. I generally haul two tractors when I go to tractor pulls. My total scale weight is 28K and I don't have any problem running at the speed limit. Very seldom do I have to shift down to 3rd over unless I'm pulling a pretty good grade. In 3rd over I can run 55 mph at 3500 RPM. I never run any higher RPM than 3500. I've had this truck since new and I would not trade it straight across for any of the new trucks.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|