Farmall & IHC Tractors Discussion Board |
Rear tire sizes treads
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Harold H on March 14, 2002 at 06:01:59 from (207.244.60.88):
Sometime in the last few days somebody asked a question about rear tire sizes. In the old size designations such as 11-38, 12-38, 13-38, etc, the first number indicated the width of the tread in inches and the second number indicated the diameter of the rim. Sometime in the late 50's they changed to the current method of size designation such as; 12-38 became 13.6-38, 14-38 became 15.5-38, etc. In the new designation the first number is the cross section width of the tire in inches and the second number is the rim diameter in inches. On most bias tires the cross section aspect ratio is approximately 1 meaning the cross section width of the tire is about the same as the cross section height or the tire. If the tire is a radial tire, designated by a "R" on the size, most also have a cross section aspect of approximately 1, however the overall ride height of a raidial tire of the same size as a bias tire will be slightly lower because the radial tire has much more flexable sidewalls. Some tires are low profile tires designated by a "L" on the size. These tires usually have a cross section aspect ratio of approximately .75 or .80 meaning the cross section height is about three quarters or 80% as much as the width. Basic tread types are designated R-1, R-2, R-3, and R-4 or modifications of these tread designs, R-1 being regular tread lugs, R-2 being rice and cane lugs, R-3 being diamond or block tread, and R-4 being industrial type lugs. Harold H
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|