Farmall & IHC Tractors Discussion Board |
SMTA hydraulic pump problems
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by boog on March 12, 2002 at 21:40:03 from (66.73.129.84):
I bought a SMTA this summer and at the time hydraulic pump appeared to work. At least when I pulled back on flow control lever the motor would pull down and the remote hoses would jump as if under pressure. Recently I bought a Behlen p.s. unit for this tractor. When I installed it I could not get it to work. Checked the flow control valve and it was froze up. Got that cleaned up but it appears pump is not putting out pressure. Engine no longer pulls down when activating flow control. Inserted preesure gauge into the remotes but could not get a reading. I am not sure if pump is getting hyd fluid and am worried that pump maybe burned up. We used this tractor last fall to auger 50-60,000 bu of grain, but never used the hyd. When I checked with CIH dealer the parts man said there was no repair kit avaiable nor pump. Hoping someone could help me with this problem. TIA boog
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|