|
Farmall & IHC Tractors Discussion Board |
Re: 53Cub hydrolic oil leaks in crankcase?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by George Willer on March 12, 2002 at 07:36:15 from (64.254.131.214):
In Reply to: 53Cub hydrolic oil leaks in crankcase? posted by Jim C on March 11, 2002 at 23:08:15:
Jim, You need to replace the o-ring seal on the pump shaft. It is a common 1/2 x 11/16 x 3/32, available at any auto parts store for a few cents. Get several, in case you mark one on assembly. Lube it good. It isn't a difficult job. You will also need 2 - 11/16 x 7/8 x 3/32 o-rings for the manifold to pump flange seal. Don't ask your IH dealer...he'd rather sell you a replacement pump for mega-bucks. My dealer says pumps are not repairable. Hah! The dealer would be the place to get the necessary gasket for the manifold to touch control unit. George Willer
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Pop's Tractor of Gold - by Gary Teate. My father was a simple man but could repair just about anythin mechanical that was ever made. From the time I was a young boy growing up in Jacksonville, Florida, I would spend a considerable amount of time helping my father repair or rebuild equipment and engines, etc. on our 2 1/2 acre "spread". Pop always dreamed of having more acreage out in the country where he could retire and tinker as much as he wanted and often reminisced about his boyhood days on his grandfathers farm in Montecello,
... [Read Article]
Latest Ad:
1952John Deere MT tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
