Farmall & IHC Tractors Discussion Board |
Re: Straightening a bent fender
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Soldan on March 10, 2002 at 14:40:11 from (216.46.130.15):
In Reply to: Straightening a bent fender posted by Doctor Dave on March 09, 2002 at 17:25:02:
Doctor Dave, taking the fender off is the best bet. I had an H fender with a terrible crease in it. I laid it flat under my Case tractor and using a bottle jack between the drawbar and the fender positioned on the ground straddling two 2x4's I was able to easily jack the crease out of the fender . then some work with a ball peen hammer and anvil and the fender was ready for some spot putty and primer. Good luck from Mike in Exeter Ontario
Follow Ups:
Home
| Forums
Today's Featured Article -
Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|