|
Farmall & IHC Tractors Discussion Board |
Re: Re: M assembly line build sheet
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jeff on March 10, 2002 at 09:09:32 from (209.43.57.71):
In Reply to: Re: M assembly line build sheet posted by mjd on March 10, 2002 at 00:16:30:
I wish I had a scanner, I would show everyone. It is the card that has all the options that the dealer or purchaser required on the tractor. The features on it with the part numbers. On this card it shows that it came with Goodyear 12-38 6 plys, rear wheel weights, hydr. lift, pto, belt pully (code 6018 49265-DB) Radiator Shutters (57557-DB) fenders (51499-D) swing drawbar 49204-db and 351927-r94 Hy. Seat. Engine serial FBKM218697 Chassis serial number 227697. fuel Gasoline (5082) Tractor has no info in columns for front axle, low speed gears, skid rings, rear lights, air pre cleaner, heat ind, clut. shift lever. From stories I know it was a narrow front, thus no option marked for front axle. I am assuming it did not have those other options either. hope you find your Assembly Line schedule Card Thanks
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|