|
Farmall & IHC Tractors Discussion Board |
1456 Oil Pressure Problem
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by bduval23 on March 03, 2002 at 18:42:30 from (63.167.48.223):
Howdy, looks like I found the right place. Anyway I have a Farmall 1456. I had been sitting for a few years, and I got it. Had a broken cam gear, tore the the engine down fixed it. Got it going but I can't seem to get any oil pressure to show up on a test guage. I know it is pumping oil because it filled the filters up just cranking it, and I found an oil leak. I pulled the stock tellight out, and if you crank it up it will pour oil out there, but I can't get anything to show on my guage or on the stock light. Is that not a pressure port? Or do I have problems. Any help or info on this tractor would be greatly appreciated. Thanks BD
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Engine Basics: Spark Plug Cleaning - by Staff. Cleaning procedures: Brush or blow dirt from around the spark plug base. Remove the plug with a correctly fitted wrench. Examine the porcelain insulator and points. If the insulator appears to be melted or blistered, cracked or broken, and the points seem unduly burned it is evident that the plug is operating too hot and it should be replaced with a colder plug. If the plug is fouled excessively with carbon it apparently is operating too cold and it should be replac
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|