|
Farmall & IHC Tractors Discussion Board |
Re: F-20 F4 Mag Help
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Charlie on March 03, 2002 at 12:49:04 from (209.130.133.177):
In Reply to: F-20 F4 Mag Help posted by Kenny on March 03, 2002 at 12:44:20:
When you turn it do you hear the impulse coupling work. If not I would start there. It could be you need new points and condenser. Have you had the cap off to see if the carbon rods are OK and have a spring behind them. You could also have a bad coil but I would check all the other stuff first - a coil isn't cheap. Points, condensers and coils are available from NAPA. I also had the pin that shorts it out when you shut if off fall out once and it landed in the right spot to be shorted out all the time.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|