|
Farmall & IHC Tractors Discussion Board |
Exhaust popping W-9 Question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kirk in PA on March 03, 2002 at 10:05:19 from (67.200.143.202):
My W-9 has some popping in the exhaust that seems to be nagging at me lately. Probably just because I haven�t done much work on old tractors this winter and I�m looking for an excuse to think about them. I restored it last winter and then noticed the popping in the exhaust last summer. Prior to restoration, I thought that I had adequately checked the engine since it ran good (don�t remember the popping), checked compression (all cylinders between 99 and 105 psi), and did an internal inspection by removing all engine pans and covers and cleaning thoroughly inside. All lifters and pushrods were removed and valves adjusted properly with engine good and warm. I then proceeded to do a thorough cosmetic restoration. I then noticed the exhaust popping that sounds like an occasional engine miss. - Does not pop until after running about 30 seconds. - Points are set properly and are new along with all other ignition components. - Dynoed it at a show last year - 53 pto hp and no popping symptoms under the load. - Does not seem to pop when opening the throttle while driving. - A very faint blue orange flame can be seen while driving at night. - No muffler, just a 18� straight pipe (sounds awesome) My question is - could this be an exhaust valve that does not seal well? Could it be the straight pipe? I have been told everything from �this is normal for an IH� to �governors can cause it to act like this� to �burned exhaust valve�. What do you guys think?
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|