Re: 806 oil lead

Posted by ihdoug on March 01, 2002 at 21:19:33 from (207.230.218.103):

In Reply to: 806 oil lead posted by wade on March 01, 2002 at 11:28:11:

I had the same problem with my 1206 and this seemes to be common with IH motors with this oil settup. Didnt leak very much, and seemd to quit leaking as the motor warmed up. I was told by a guy who had this problem with their 1456 and 856 that they tried replacing rings and sealant but it will eventually leak again unless you replace all the tubes and ends, which would get pricey. All I did was took the tube out, which took a little wiggling and turning, and clean the entire surface and ring with ether, which dries 100%, then spread silicoln on the surface. Did it last spring and hasn't leaked yet. Alot cheaper than replacing all those parts.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: 806 oil lead Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]