Re: Behlen power steering installation - need help

Posted by One way to do it. on March 01, 2002 at 07:02:11 from (152.163.213.84):

In Reply to: Behlen power steering installation - need help posted by PaulH on February 28, 2002 at 15:08:24:

I have a Behlen unit on a M and it is a simple job to install. My unit has a Behlen pump mounted behind distribitor like factory or M & W pump. The resivoir is a fabricated steel tank that mounts were small gas tank on distillate model would go. The plumbing goes from bottom of tank to suction side of pump to high pressue side of unit and back to tank. This unit is mounted over valve cover and braced to casting that supports center of steering shaft. The unit fastens directly to shaft from steering wheel but shaft to steering gear must be shortened and new key way cut. This set up works fine but hood must be modified to clear unit and casting it is braced to is prone to breaking. Hope that this might help.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Behlen power steering installation - need help Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]