|
Farmall & IHC Tractors Discussion Board |
Re: Re: 574 IH HYRAULIC FILL LOCATION
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JWC on February 25, 2002 at 14:55:16 from (130.74.184.124):
In Reply to: Re: 574 IH HYRAULIC FILL LOCATION posted by Diesel Bob on February 24, 2002 at 11:14:29:
Bob,
I have a 574 we purchased new in 1973 in the U.S.. I have been told that the graymarket 574s which started showing up here in the early 90s had different hydraulic systems from those made for U.S. sales. Do you know if the hydraulic systems are different based on which market the tractor was produced for? I would like to add a second spool to my tractor, and am assuming that the second spool sandwichs between the first spool and the endplate of the valve unit.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
