Farmall & IHC Tractors Discussion Board |
Re: Re: Farmall 130 clutch problem
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on February 23, 2002 at 15:14:29 from (142.177.87.203):
In Reply to: Re: Farmall 130 clutch problem posted by John in Maryland on February 23, 2002 at 14:21:47:
John: Yes the 130 does have a grease fitting. I have changed a dozen or so clutches in my day and this is the first time I've had this problem. My first thoughts are that I didn't get that lever back to the right shape. The clutch and preasure plate were rebuilt ones from CaseIH dealer. If I adjust clutch pedal to point where release bearing is in contact with preasure plate fingers, the problem will not ocur. At that point the clutch pedal is about 1/4 to 3/8 inch from platform. I also have a Super A, changed that one two years ago, no problem. When I was farming I had a dozen Farmalls to 1066 in size. 1066 is only one I never changed clutch in. So its not like it is the first one.
Follow Ups:
Home
| Forums
Today's Featured Article -
Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|