Farmall & IHC Tractors Discussion Board |
'50 Farmall H front end
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Krey in Indiana on February 11, 2002 at 12:53:13 from (216.107.77.169):
I have a 1950 Farmall H rowcropper (narrow front end). The steering has a good deal of play (about 1/4 turn of the steering wheel). After inspecting the steering system, the worm gears and u-joints seem to be in good shape. However, there is play at the top of the front steering shaft (the large horizontal spindle). The nut on top holding the sector gear seems to be tight, so I'm assuming the front spindle needs to be rebuilt. Also, when filled with 80 wt lube, the lube just pours out the bottom of the steering gear housing. What is involved in removing the front spindle, and can it be done in a well equipped home garage? How is the spindle removed, and what might be required in the way of parts for the rebuild?
Follow Ups:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|