Farmall & IHC Tractors Discussion Board |
Re: Int. 504 No spark at points.(Help!)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Matthew on February 10, 2002 at 10:15:12 from (64.68.163.39):
In Reply to: Int. 504 No spark at points.(Help!) posted by Scott Pahos on February 09, 2002 at 18:38:05:
Do you have 12 volts at the points with just the switch on? The only time you should have 12volts at the points is when you are cranking the engine. There should be just a tad over 6 volts with the switch on. If not you have a problem with the resistor. Do you have a 2 wire solenoid? There should be a wire on the R terminal. This gives you 12 volts at start up. When the solenoid kicks off after start up, then you should have less than 12volts. If you have 12 all the time that's why your points are burning.
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|