Farmall & IHC Tractors Discussion Board |
Re: simple question H bolster
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jal-SD- - Ron, I think that wedge like... on January 29, 2002 at 07:08:35 from (64.68.166.199):
In Reply to: simple question H bolster posted by Ron in Az on January 28, 2002 at 20:25:53:
...spacer is an "after market" addition that was available through IH to make the narrow front tractors steer easier when heavy front mounted equipment (like a cultivator) was used. It went in to adust the camber ("tilt") of the front wheels. The wide part of the wedge goes to the rear of the tractor. It also increases the turing radius, I think. On my 3 H's, two have wedges & one doesn't. The one that doesn't is a '44 & its the one that I grew up on so I know its history since it was brand new. They may have come in different thicknesses, as one that I have looks wider than the other one, but I haven't measured them. I also know that one of my H's spent much of its life under a loader & it has the wedge that looks wider in it. (My $0.02 worth. jal-SD)
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|