Re: No Oil Pressure on rebuild

Posted by Janicholson on June 19, 2007 at 12:42:39 from (66.173.50.10):

In Reply to: No Oil Pressure on rebuild posted by Thomas D Windsor on June 18, 2007 at 20:09:33:

A great old trick to fix the current ill.
Take a pump type oil can, slip a 1/4 id rubber hose on it and a small hose clemp to hold it in place. Pull the oil pressure line out of the block, and thread in the other end of the hose. Put engine oil in the oil pump and start pumping. This may take 15 minutes, and several loadings of the oil can. when it is full, the oil can will pump much harder. Then put the gauge back in and fire it up. Low tech handy, and very effective. JimN

Replies:

• Re: No Oil Pressure on rebuild Thomas D Windsor 14:05:36 06/19/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]