|
Farmall & IHC Tractors Discussion Board |
Hydraulic problem 460 Mc -Farmall
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ol Chief on June 05, 2007 at 19:12:33 from (69.91.92.199):
I am having a constant hydraulic overload on the engine. The only way to relieve the engine load is to operate the hydraulic system. On two previous occasions I cured the situation by removing the valve block and cleaning the tiny 300 mesh screen which is fitted to the small ball check valve.I have mislaid my shop manual,so no longer have a trouble shooting guide.I noted that the small pin to prevent loss of the tiny ball bearing was missing so I fitted a new retaining pin.However I do not know if there is a spring required to seat the ball.If so then it has been lost.I just finished this chore and test ran the tractor. I still have the same overload.I am hoping someone can help out on this problem. Thanx
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
