Re: ih 350u clutch adj (again)

Posted by the tractor vet on June 05, 2007 at 19:02:39 from (75.19.120.54):

In Reply to: ih 350u clutch adj (again) posted by lester350u on June 05, 2007 at 18:42:46:

You got problems somewhere as the release bearing should have more clearance then that . and when the speed of the engine increases the finger should not move out this is not a Crowler Glide . Whenya installed that new clutch did ya hve the flywheel ground and the pressure plate step cut like you should have ??? I would say that the disc is setting down in the flywheel to far and this is allowen the fingers to come out way to far . Once free travel is set the throwout bearing should never touch the release fingers.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]