|
Farmall & IHC Tractors Discussion Board |
Re: fast hitch mower to a IH 240 utility
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by bil b va on June 03, 2007 at 08:42:29 from (209.240.206.210):
In Reply to: Re: fast hitch mower to a IH 240 utility posted by georgeky on June 03, 2007 at 04:27:21:
thanks george . i was a little lost until i studied what you said and looking at the tractor and mower . i take it the idea is to attach a chain to the lift mechanism and to a stationary point on the tractor and as the hitch is raised it rotates the lifting shaft to raist the blade. is this what happpens right now i have the mower temporally on my 300 U and doesn't look like the bottom of the lift cylinder would be the place to attach the chain . i just picked up this mower yesterday and it was from a super C . i removed the lifting rod for the super c . is the axle clamp on the right side of the mower necessary on the 240 U or 300 U ? before i attempt to use the mower i want to go over it and adjust and check things out . the bar has a bow in it . placing a 4 foot straight edge on the back side of the bar from the inner side out there is about a 1/2 inh bow in the bar at the 22 inch point . is this accptable ? hope you don't mind me picking your brain for info . i have a parts list and operator's manual but there are unanwsered questions . i remember the horse drawn mower my uncle used on my grandfthers farm back in te 30' and after WW 2 a allis charmers tractor he bought after he got out of he army
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Step by Step Carburetor Overhaul - 1952 Ford 8N - by Don Stewart. The carburetor kit for the TSX-241A/B/C carburetor is being supplied in only one flavor nowadays. It includes a replacement throttle shaft, new butterfly valve screws, fuel inlet filter, new float needle and seat, new float pin and
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|