Re: im not getting power that turns the mag

Posted by D Slater on June 02, 2007 at 03:47:16 from (72.65.156.125):

In Reply to: im not getting power that turns the mag posted by jonnnny2006 on June 02, 2007 at 00:00:53:

Crankshaft gear turns a idler gear,idler gear turns cam gear the one you can see in hole where you removed mag. drive. Can you roll that gear 360 degrees manualy through mag. drive hole to inspect teeth? Its not very common for a cam gear to fail on those engines. The idler gear runs on bearings that can fail. Injection pump gear drives from idler gear. You could remove cover from front of injection pump gear and see if it turns to narrow problem down, but think the hole front cover will end up being removed in the end. Injection pump may have locked up and caused a gear to fail or lots of other things. Can't remember right now if any of bolts in mag drive mounting will hit cam gear if to long like on gas engine. Like some others said you need a manual.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]