|
Farmall & IHC Tractors Discussion Board |
MD help please who know diesel
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jonnnny2006 on June 01, 2007 at 23:49:06 from (67.142.130.18):
I have a md and the part you bolt the magnto to dosent spin when you crank the engine over. im wondering what could cause the part the mag gets its power from to fail? also does the power that goes to mag also power the diesel pump? I'm thinking there is somthing wrong in the front of the engine. i need a breakdown of what the engine parts on the inside look like. I dont wanna take the whole thing apart if i dont have to. could there be a bad shaft that failed? My magneto works fine by hand but the part that is supposed to spin it on the engine dosent even spin with the magneto compleatly off. Are there web sites that i can go to to see the scewmatics of the md? or do i need to get a servise manuel for the md? i have never done a diesel before. i have rebuilt trannys in cars and there hard so if i can to a automatic tranny overhaul I think I can handel this diesel. any idea where to start to look for a bad part? i dont know what would fail and make the part that feeds the mag to fail. I see that part that dosent spin like it should can be unbolted from the block might there be somthing in there that might be broke?
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
