|
Farmall & IHC Tractors Discussion Board |
Re: grinding going in gear
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by City-Boy McCoy on June 01, 2007 at 15:55:32 from (65.0.156.211):
In Reply to: grinding going in gear posted by don sloan on June 01, 2007 at 10:22:33:
I have two Super A's and have owned four in total. Unless you depress the clutch and wait several seconds, in most cases it is going to grind. You need to depress the clutch and wait for the gears to stop spinning. The gears are not synchronized in these old tractors. You have to wait for them to stop turning. I will say this: the grinding seems to be more prevalent if the tractor is equipped with a Rockford clutch. However, the Rockford is such a superior clutch to the Auburn, it is worth the minor delay. mike
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
65 Massey FERGUSON DIESEL
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
