|
Farmall & IHC Tractors Discussion Board |
Re: Farmall 340 Plowing Question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by georgeky on May 24, 2007 at 06:23:33 from (205.188.116.138):
In Reply to: Re: Farmall 340 Plowing Question posted by MN Mike on May 24, 2007 at 05:35:58:
A turning plow was designed to plow deeper than 4 inches. If that is as deep as you plow you might as well use the disk. Run it down to 8 or 10 and see how it works. I have a 311 3x 14 fasthitch plow and a no.531 3x14 3ph plow and I can tell you from past experiance it will not pull either in the ground 8 or 10 inches deep. I know someone is going to say a 14 inch was designed to plow 7 inches deep and the 16 8 inches deep, but they will plow well at deeper depths.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
The David Brown Rose Badge - by Samuel Kennedy. In the 13th century civil war was raging in England. Two English noblemen were involved in a conflict which became known as the War of the Roses. The Duke of York had as his emblem a white rose and the Earl of Lancaster had a red rose. Today the white rose is the official emblem of the county of Yorkshire and the red rose has been adopted by the neighboring county of Lancashire.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
