|
Farmall & IHC Tractors Discussion Board |
Are you guy's holding back your tricks? ; )
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by neblinc on May 23, 2007 at 06:13:50 from (24.123.122.114):
Well those darn dowel pins are what held me up. I thought that nuts were just missing on them to hold the engine ; ) Once I got the engine out a little farther I could see what the problem was, put a nut and washers on them and pulled them out. Oh and to Tom Windsor, I was dreading pulling that fan pulley after you said you broke yours, I went to put the puller on and started to tighten it by hand and it started to pull right off LOL! Mike CA wanted me to post pics of my progress so the link below is my quickie web page. Clicking on pics will open a new window with bigger photos, or you can start a slideshow by clicking the button at the top of the page. Many thanks to everyone on these forums for the helpful info and tips (well some I have to figure out on my own) Now comes the removing of the pistons for my next project. I am sure I will be asking for more help ; ) Randy
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
More Memories of a Field Service Engineer - by Brian Dye. Introduction: The author worked for one of the largest Ford tractor dealerships in England as a trouble-shooter on tractor engines, hydraulics and combine harvesters from 1963 to 1972. In 1972 he became a dealer manager and finally left the dealer net in 1975 to run his own electronic design and manufacturing company. [Editor] We live right in the middle of Norfolk. The dealership that I worked for sold Fordson Tractors from the 1920's and some of t
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
