Re: 1066 Range Trans Linkage Problem

Posted by the tractor vet on May 21, 2007 at 08:03:58 from (75.19.123.226):

In Reply to: Re: 1066 Range Trans Linkage Problem posted by Michael Sheik on May 21, 2007 at 07:53:23:

The roll pin was put in by someone elseas they are or were suppose to be a tappered Groved pin as the holes were tappered drilled , but over time they got woren and that pin fell out and someone drilled stright thru with a 1/4 inch bit . Makes it easier when one must take one apart . as for doubel pinnin thats fine drillen out to 5/16th thats ok TILL it starts getting sloppie then there is noplace to go the next time other then MAKEN up a new special pin to take up slop.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]