Farmall & IHC Tractors Discussion Board |
Re: Boredom = garage cleaning + pics + product rev
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Al L. in Wisc. on May 13, 2007 at 17:06:52 from (207.190.67.77):
In Reply to: Boredom = garage cleaning + pics + product reviews posted by Steven@AZ on May 13, 2007 at 14:17:22:
Steven, I just have a couple tips. In the top photo, just above the floor jack, would you please turn that square piece of plywood around so nobody has to look at the tire scuffing. Now, just one more thing, turn the square piece of metal with the numeral 1 in an upright position. You don"t know when a neighbor might walk up to the open garage and see such untidy conditions. There, that should just about do it. Oh, ya know if it were me...I would stack my four rear IH wheel weights on the floor to cover up the oil stains I see in the second from the bottom photo. But then you don"t have four wheel weights do you.
Replies:
Home
| Forums
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|