|
Farmall & IHC Tractors Discussion Board |
C gas tank
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Karl Hamson on May 06, 2007 at 19:09:42 from (139.142.96.209):
A day of dreary rain instead of the promised sunshine so I decided to tackle the fuel starvation problem on my C. I pulled the tank and as expected there is lots of rust and other crud. Any good ideas about getting this stuff out? I thoughtI might throw in a few pounds of clean pea gravel, put on some good rock and roll and shake it. The paint is pretty good so I don't want to send it in to get tanked. I have read here about extending the inlet upward 1/2" or so which seems to be a good idea except you can never drain the tank should you ever want to. I thought I would stick a piece of 1/4" copper tube into the existing hole. Will this restrict fuel flow too much? Also the gasket for the sediment bowl is bad. I have some 1/8" sheet neoprene will this stuff work or will the gas attack it? Thanks, Karl
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
History of the Nuffield Tractor: Conclusion - by Anthony West. In the last piece I mentioned that Nuffield had reached the stage where they had chosen to drop the "Universal" from production. The two new models were given three figure numbers, instead of "three" and "four". Model numbers were introduced to help farmers and dealers instantly recognize the engine size and horsepower of the tractor, the 4/60 had a four cylinder diesel engine which developed 60 bhp at 2,000 rpm. The 3/42 had a 3 cylinder diesel engine which produced 42 bhp at 2,000 rpm. Th
... [Read Article]
Latest Ad:
1952John Deere MT tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
