|
Farmall & IHC Tractors Discussion Board |
Re: can not get above 1500 psi
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on May 03, 2007 at 07:03:05 from (76.212.224.60):
In Reply to: can not get above 1500 psi posted by danny beach on May 02, 2007 at 18:01:55:
And WHY do you need more pressure???? , if you are getting 1500 lbs. on a 560 that will do almost everything that ya need to doif the hyd. cyl. is the correct one . Now if you had some mickymouse loader set up that has to small of lift cyl. and your tryen to lift something then you can push up the pressure but keep in mind here that the system can only handel so much . At 1500 lbs. that system will lift a 12 ft. disc. with a 3x8 cyl. or a 540 fourbottom plow on a 2x8 cyl. as for loader operation then there should be three inch dia. cyl. on the lift arms and 2-3 inch. on the bucket .IF ya are using it on a log spliter and it is short on power move up to a 4 inch dia. cyl.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
