Re: farmall a hand crank

Posted by Roger46 on May 02, 2007 at 19:36:02 from (69.58.159.118):

In Reply to: farmall a hand crank posted by nspec on May 02, 2007 at 19:07:47:

The crank for the A is a simple one. I made one using another one as a pattern. Basically is is a 3/4 inch diameter shaft bent in two places and then it has a 1/4 inch pin driven all the way through a hole in the end. So, yes, the pins are on opposite sides of the shaft and should be in about 3/4 inch from the end (I didn't measure, just estimated). Roger

Replies:

• Re: farmall a hand crank nspec 01:59:49 05/03/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]