|
Farmall & IHC Tractors Discussion Board |
Re: Farmall C identification
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Randy in NE on May 02, 2007 at 14:59:32 from (204.124.193.192):
In Reply to: Farmall C identification posted by dave in NB on May 02, 2007 at 14:24:12:
The C came with a 113 CID engine with 3" bore and 4" stroke. Some of them have been bored out to 3 1/8" bore making it a 123 CID which is the same as in the Super C. You won't know for sure until you pull the head. When I replaced the head gasket on one of my C's I found out that it had been bored out. It is hard to find a head gasket for a 123 CID C engine which is a thermosyphon system. The Super C water ports are much smaller than the C.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather�s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
L35 Kubota
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
