|
Farmall & IHC Tractors Discussion Board |
Re: C263 rod installation
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by turbos10 on April 22, 2007 at 19:21:35 from (71.48.169.238):
In Reply to: Re: C263 rod installation posted by El Toro on April 22, 2007 at 10:09:52:
Hehe...that would be a bit tough to get rolling I suppose. I would definately get to test out the new 2 disc slipper.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Step by Step Carburetor Overhaul - 1952 Ford 8N - by Don Stewart. The carburetor kit for the TSX-241A/B/C carburetor is being supplied in only one flavor nowadays. It includes a replacement throttle shaft, new butterfly valve screws, fuel inlet filter, new float needle and seat, new float pin and
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
