|
Farmall & IHC Tractors Discussion Board |
Be Forwarned!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by A. Bohemian on April 20, 2007 at 11:43:01 from (207.170.88.29):
In Reply to: Tune-up --- posted by jis on April 20, 2007 at 08:31:31:
As Dell says, what aren't you telling us? Is the tractor running rough? Unless you see visible damage on the cap and/or rotor, they are not likely to be the problem. Don't discard them unless the motor runs better with the new ones; that way you will have spares! I have seen a tractor (two-cylinder Deere) run with the copper contact on the rotor broked off. The spark easily jumped the half-inch gap and the tractor had been running well. Embarrasingly, we had let the tractor run out of gas. After we added gas and she started right up, we put the old, broken rotor back in just for grins. She fired right up and pulled well. So, the problem is not likely to be the cap and rotor. They DO go bad; but not often. Instead, pay careful attention to the condition of the plugs. Surface rust means they haven't been changed in a while and may just have died of old age. But if you see a lot of oil on one of them, check the compression on that cylinder.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Proflie: Farmall Model C - by Staff. In 1948 the first Farmall Model C tractor rolled out of the factory and into the farmer's field. A follow-on to the Model B, it was slihtly larger in size but kept the same 113 CID engine and 4-speed transmission. Other upgrades included adjustable rear tire spacing (with sliding hubs), a frame design similar t
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|