|
Farmall & IHC Tractors Discussion Board |
Re: M pulling 3 bottom 16 inch?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by georgeky on April 19, 2007 at 11:17:33 from (152.163.100.197):
In Reply to: M pulling 3 bottom 16 inch? posted by eshoreboy on April 18, 2007 at 17:34:24:
eshoreboy, as is plain to see there are a lot of opinions. They are all right for the most part. Different types of soil will dictate how many and how big a plow can be pulled by any tractor. I have a 3x14 number 8 little genius plow that I pull with my Ms. Early in the year it will handle them in 2nd and 3rd gear almost anywhere. Later in the season as grass and or cover crop begins to strecth its roots and ground becomes drier and tougher the plow becomes harder to pull. I have seen ground here in central Ky that gets so tough an M will barely handle 2x14s. I once seen a 2510 JD pulling 5x16s in bean stubble in southeast Nebraska along the Little Blue River, and doing a good job. The 2510 here in Ky will barely pull 3x14s early in the season, I have plowed with one. So I think unless you have a lot of ground to plow the 2x16 will be a better choice for you.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|