|
Farmall & IHC Tractors Discussion Board |
Concerned about H temperature follow-up
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Gary Puckett on April 07, 2007 at 19:45:01 from (64.130.139.197):
JimN,This was your response to my former post. Thank all of you for taking time to repond."Rusty and Tom are very correct. I would put a candy thermometer in the radiator and warm it up. If the temp gets near 205, I would look at the cooling system to get it clean. A flush and rinse with a good flush product. If the real thermometer stays in the 160 to 180 range, that should be the mid range of the run area. Do not get it as hot as the top of run and then remove the cap, you will be scalded. Good luck, JimN" I did exactly as you suggested. The candy thermometer did not get above 165 when the guage was at the high end of the "run" section. Would you suspect the guage at this point. It is the proper one according to the year (1947).
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|