Re: SC Crankshaft Pulley

Posted by Keith-OR on April 03, 2007 at 09:33:59 from (207.200.116.73):

In Reply to: Re: SC Crankshaft Pulley posted by teddy52food on April 03, 2007 at 05:46:59:

Here here teddy, seems like I posted a picture of the puller and square tube I used to remove AND install pulley back on the crank awhile back.

The holes are 11 3/4 center to center, I used 5/8 althread 24 inches long. Used hydraulic jack with a 1/2" by 2 1/2" diameter plate against the pulley.

Caustion!!! be sure to leave the front housing loose, so the seal will center properly on the pulley...

Keith & Shawn

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]