|
Farmall & IHC Tractors Discussion Board |
Crank Seal
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tom Windsor on March 26, 2007 at 12:16:22 from (69.40.61.69):
The front crank case seal on my H rebuild is causing me some mental activity. Looking at what I have, there were two seals in there. One of them felt. The kit people sent me a felt seal to go up there. I pusted, shoved and was gentle with it and still destroyed the holder getting it out. The seal had a number on it so I went to local seal shop and they cross indexed it to a seal that fits the hole but it is rubber and not felt. it is very narrow and there is room for two of these seals to replace the old thing. I was wondering out loud if it will be satisfactory for me to replace the felt seal up front with two rubber seals. Anyone have any experience with this? It seems to me that it shoud be ok. TW
Replies:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
