Farmall & IHC Tractors Discussion Board |
Re: SMDTA problems - convert to gas only
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Farmallkid From Ont, on March 24, 2007 at 20:29:06 from (209.216.154.123):
In Reply to: Re: SMDTA problems - convert to gas only posted by georgeky on March 24, 2007 at 19:57:58:
Haven"t bin on here for awhile, but when i was on cnks give me some good advice, but i never seen you on here before, at least cnks give what he could to this post, and you done nothin but put people down, the mechanic in town got on me the same way about the motor\engine thing, it is a simple mistake made by most people, including peole who know there stuff. I just tell the mechanic to f off, and that fixed him from havin a bad attitude towards the subject. If ya don"t got helpful advice, or somethin nice to say dont write it, but if ya do please share your knowledge.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|