|
Farmall & IHC Tractors Discussion Board |
Re: Looking at a 826
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bradford on March 24, 2007 at 12:35:04 from (72.181.180.134):
In Reply to: Looking at a 826 posted by Bradford on March 24, 2007 at 11:24:04:
Makes we want to drive the 70 miles again to check the fuel shutoff cable. it was pushed all the way in when starting. hate the idea of using ether. starting to feel like it"s mine and don"t want owner starting with ether to demo it for other folks. There isn"t anything on the pto valve. Just a rope with the bunge cord to hold the valve up. The valve was down when the engine was running and i pulled kinda hard on the rope which lifted the valve but the pto"s didn"t stop. maybe i didn"t pull hard enough. The tractor is kinda rough, but for 3750 i might go for it..
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Talk of the Town: Removin Broken Bolts - by Staff. Another great discussion from the Tool Talk Discussion Forum. The discussion started out with the following post: " How would I remove a bolt thats broken off in a piece of metal and I want to save the treads in the metal and then put in a new bolt. "
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|