|
Farmall & IHC Tractors Discussion Board |
Farmall C Starter Question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Kenneth Fass on March 23, 2007 at 08:04:43 from (64.73.36.192):
The starter on my C suddenly failed. It turns out there is nothing wrong with the starter motor itself, nor the starter switch. The problem is with the copper "node" that the starter switch contacts to make connection. It is severely worn from years and years of use - to the point where it no longer makes contact when the switch is engaged. Is this part serviceable? It looks like it might be, but I did not spend any time yet looking further into it. I think I could resolve the problem by ROTATING the note 180 degrees actually. (I got around the problem temporarily by removing one of the starter switch mounting screws. This allowed the switch to "skew" when engaged - which allowed the motor to start) Thanks!
Replies:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
