|
Farmall & IHC Tractors Discussion Board |
Re: super a seals
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by SuperA-Tx on March 14, 2007 at 06:42:52 from (4.90.12.117):
In Reply to: Re: super a seals posted by scotty on March 14, 2007 at 05:04:30:
I agree Scotty. Then you also need a new gasket when you have to do that. Plus if he has a side pulley then that seal is probly leaking and will need to replace that at the same time. Need a gasket there too. Wcroom, if you have a seed drive you might want to check that for leaks. That takes a seal and a gasket. Easy job tho. Axle seals arent hard to replace if you have the right stuff to do it with. If you have weights on the wheels then I would find someone with a cherry picker to pull the wheel off with. If theres oil on the brake bands then clean them good with gas if they are good or replace them.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|